Instruments & Meters

SinceVision Introduces SGI-N030W Wide-Spot Laser Displacement Sensor for Rough Surfaces

The new sensor pairs an expanded laser spot with optical triangulation for stable non-contact measurement and synchronised thickness checks.

Aisha RahmanNovember 17, 20265 min read5 views
A conceptual illustration shows opposing wide-spot laser sensor heads measuring a moving sheet on a precision production line.

SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The sensor combines an expanded laser spot with optical triangulation and is aimed at lithium-ion battery manufacturing, semiconductor processing and precision mechanical engineering, where micrometre-level measurements are required.

Wide-spot design seeks to reduce surface noise

Conventional point-spot laser sensors concentrate reflected energy in a small area. According to SinceVision, microscopic scratches, grain boundaries, brushed textures and matte finishes can then create signal variations that the system may interpret as dimensional changes, possibly triggering false defect warnings and extra inspection. The SGI-N030W instead collects reflected light from a broader area, averaging local microscopic peaks and valleys before signal conversion. SinceVision says this reduces the influence of surface roughness and optical scattering on materials such as drawn metals, sandblasted surfaces and coated battery foils.

Specifications support fast, synchronised measurement

The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm on a diffuse white target under static conditions and linearity of ±0.02% of full scale. A 50 kHz sampling frequency, equivalent to a 20 µs update interval, is intended to support monitoring of dynamic processes. Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage. Master-slave synchronisation lets two sensors face each other and measure opposite sides of a component or moving material.

Battery electrode thickness is a primary target

A main application is in-line thickness measurement of lithium-ion battery electrodes. Coating thickness and uniformity affect energy density, internal resistance and long-term cell stability. SinceVision notes that offline contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode material, while periodic spot checks cannot provide continuous coverage across a production reel. Its proposed arrangement uses two synchronised sensors above and below a moving electrode web, mounted on a calibrated marble gantry with low thermal expansion. A controller combines the opposing clearance readings with the fixed mounting datum to calculate absolute thickness in real time.

In production trials, SinceVision reports stable, repeatable thickness measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling rate is said to provide high longitudinal resolution, allowing localised coating agglomerations, edge thinning and exposed substrate areas to be detected before the electrode moves on to cell winding.

Semiconductor and precision-assembly uses

The sensor is also intended for semiconductor manufacturing, where non-contact measurement is important for sensitive wafer surfaces. Potential tasks include wafer position verification, edge detection, height measurement, and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, it can monitor voice coil motors, linear actuators and micro-steppers. Its sampling rate is intended to capture transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot. Position data can be sent to machine controls over Ethernet for real-time monitoring.

Company cites false-warning problem

Jack Li, SinceVision’s global sales and marketing director, said false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He said conventional point-beam sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating additional manual inspection needs. The SGI-N030W’s expanded spot is designed to average out such surface-related variations, while opposing sensor heads are synchronised to support high-speed thickness verification.