Automotive Accessories

Jeep Builder Fashions a Budget Rear Portal Axle by Flipping the Differential

A builder combined a Ford 9-inch housing with Humvee geared hubs and an inverted differential to gain about six inches of clearance at a fraction of typical portal-axle cost.

Astrid BerglundNovember 17, 20265 min read5 views
A workshop illustration shows a custom rear axle assembly with an inverted differential center section and geared hub ends, next to a tall off-road tire.

Portal axles are prized by hardcore four-wheelers because they raise a truck's ride height and its ability to clear obstacles, whether the ground is Moab slickrock or Icelandic volcanic terrain. The drawback is price: a typical set from companies such as 74Weld runs about $20,000. That is what makes the build by Zeph Gage stand out — a rear portal axle that costs roughly a fifth of that figure.

What a portal axle does

As The Drive's Andrew Collins has explained, portal axles are simple in concept but remarkable in practice. Instead of letting shafts and other components hang below the transmission and transfer case, they place a stack of gears behind each driven wheel. That arrangement lets the axle shafts sit high, leaving very little hardware below the frame line. Combined with tall tires — he cites 37-inch BFGoodrich KM3 mud terrains — the setup can open enough room to have a picnic beneath a parked truck.

The parts and the flipped differential

Gage's assembly pairs a Ford 9-inch axle housing with geared hubs taken from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals like the Humvee's reverse the rotation of the input shaft. To compensate with the Ford 9-inch, Gage turned the differential upside down so the driveline spins in the correct direction, then bolted a Yukon Gear and Axle third member to it. The result is effectively a budget high-pinion unit built from low-pinion parts that have simply been inverted.

Why only the rear

Beyond adding about six inches of clearance, the arrangement retains full shock travel — something the story notes is tricky to achieve with portal axles — and reduces stress on the differential, factors it says should make the setup effectively bulletproof.

Fitting a portal at the back without matching the front is a common trick in the radio-control rock-crawler scene. By keeping the solid axle up front, Gage avoids the packaging constraints that typically appear when portal axles are added to a vehicle that never had them from the factory. He also avoids having to limit shock travel because of those constraints, and the ride height does not climb absurdly high, a combination the story frames as a best-of-both-worlds outcome.

Custom fabrication and the result

This is not an off-the-shelf kit. Gage carried out extensive custom work, from homemade brackets and custom-tapped plates to a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric parking-brake solenoid and partly for clearance reasons.

The finished XJ Jeep can drive over a five-gallon bucket and still have several inches of clearance to spare. That means the rear end will not hang up on obstacles the front end can simply steer around. Gage covers the build in more detail, including how he matched gearing front and rear, in a video from Outdoor Auto.