Renewable Energy

Emulsion buffer layer curbs screen-printing degradation in copper-plated HJT solar cells

Chinese researchers link efficiency losses to wear of screen mesh knuckles and find a 4.7% emulsion coverage ratio best balances protection with uniform photoresist coating.

Dawit BekeleNovember 15, 20265 min read0 views
Conceptual cutaway of a screen-printing mesh held slightly above a silicon wafer by a thin emulsion buffer layer.

Researchers in China have traced how repeated screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design that limits the damage, according to a study published in Solar Energy.

Screen printing is a workhorse metallization step in solar cell manufacturing, but the mechanical pressure and thermal treatment involved can harm the sensitive passivating contacts of HJT devices, raising recombination losses and cutting conversion efficiency. The issue matters more as the industry looks to copper plating to reduce silver consumption and metallization cost.

Efficiency loss tracked across 15,000 prints

According to the team, earlier production data showed conversion efficiency slipping from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial manufacturing. The losses came mainly from open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed broadly unchanged. Minority carrier lifetime degradation rose from 0.61% with a fresh screen to 11.0% after 15,000 cycles.

Using three-dimensional confocal microscopy, the researchers identified progressive wear of the screen mesh knuckles as the main driver. As the knuckles flatten, their contact area with the wafer grows, applying greater mechanical stress to the passivation layers beneath. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements indicated higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.

An emulsion layer as mechanical buffer

Corresponding author Lang Zhou explained to pv magazine why the photoresist step differs from conventional silver paste printing. In silver paste screens, openings cover only 2–5% of the total area and the remaining surface carries an emulsion layer that keeps the mesh off the wafer. Full-area photoresist coating typically uses a screen without emulsion so the resist spreads evenly, which means the mesh touches the wafer extensively on every printing cycle.

To break that contact, the team added an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The results showed a trade-off: greater coverage protected the wafer but disturbed resist distribution. A 4.7% coverage ratio gave the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while keeping coating relatively uniform. The authors attribute the improvement to reduced cumulative mechanical damage to the passivation stack.

Zhou said the findings indicate that a comparatively simple change to screen design can substantially reduce printing-induced degradation, and described it as a practical way to improve manufacturing reliability for copper-plated HJT cells.

Copper metallization gathers momentum

The work lands amid widening interest in replacing silver contacts. In April 2026, researchers at China's Nankai University reported a silver-free HJT cell at 25.2% efficiency, combining plasma-induced interface engineering with copper electroplating to address adhesion, contact resistance and stability at the ITO interface. Separately, scientists at Germany's Forschungszentrum Jülich reached 23.08% with a fully copper-metallized HJT cell, a relatively small penalty against its silver-metallized counterpart; cells pairing silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results underline copper's potential to cut silver use, though further gains in processing and electrical performance are still needed.